This beautiful pressing has six adjustable ring shapes featuring sunflowers and laced edges and is part of our Cowgirl Rustic collection.
The ring sizes are 4 through 9 and can also accommodate half-sizes. Metal Maven recommends that you order 16-gauge or 18-gauge pressings for making these rings.
There is also a bonus drop that can be used to make earrings or a pendant. The drop is 13/16" tall by 7/16" wide excluding the hanging loop.
The components are part of our Cowgirl Rustic collection and complement our other Cowgirl Rustic Sunflower pressings. They are called “Cowgirl Rustic“ because they have design elements commonly found on Western saddlery and other items like Western belts and boots.
With Metal Maven’s patterned metals in your metalsmithing tool kit, your jewelry pieces will be transformed with added interest, detail, character, and charm!
Cowgirl Rustic Sunflower Rings 4-9 and Bonus Drop Copper Pressing
Usage
Metal Maven Rolling Mill Component Die Use Guidelines
These Rolling Mill Component Dies are for rolling mill use only. We tested them with a hydraulic press and we were able to get impressions. However, we also found that after the first couple of pressings the plates became dented. This happened because the type of tool steel necessary for use in a rolling mill is softer than the type of steel for using in a hydraulic press.
Your die will arrive lightly oiled with a lubricant called CorrosionX. It can be found at most auto supply stores. We highly recommend you use it or some kind of machine oil to protect your investment, especially if you live in a humid climate. We use it to keep rust from forming on our steel pieces, dies, rolling mill rollers and other tools. It also helps your silver or copper release from the die.
When you first set you rolling mill rollers, take your die and place a piece of dead soft copper on top of it. We have found that 20-gauge and 18-gauge copper works best. Then, place a piece of craft foam on top of your metal. Place them into the opened rollers of your mill and gently close your rollers until they touch the top of your die, metal, and foam sandwich. Try rolling your die at that setting first to see if you get an impression. If you do not get a good impression, adjust your rollers tighter and test again. Rolling too tightly could damage your die or cause your die to form a drastic curve, so be careful to tighten in small increments.
You can find the craft foam on Amazon - search for Darice 2mm Foamie Roll, 36-inch by 60-inch, black.
Return and Refund Policy
Please check the sizes carefully when ordering, as we do not accept returns or exchanges.
Please note that we check the quality of each die carefully before we send them out.
Shipping Info
We offer shipping via USPS. Your shipping options will appear in your shopping cart. Shipping Insurance is included on all orders.
